Removing floor of 5th gen

Support for the CO2 Laser Products

Re: Removing floor of 5th gen

Postby fullspeceng » Thu Jan 31, 2013 5:08 pm

Yes just remove all the small button head screws that hold down the silver aluminum bottom. Don't remove the big black screws that hold down the corner brackets.

Avoid stripping screws when removing them.

Reinstall the screws by pushing the installed t-nuts using a paper clip through the slots cut in the bottom.

Both reinstalling and removing is much easier if you flip it upside down to see what you are doing.
fullspeceng
Site Admin
 
Posts: 900
Joined: Tue Aug 17, 2010 1:59 pm

Re: Removing floor of 5th gen

Postby amboggeri » Mon Feb 04, 2013 1:16 pm

Another tip: if your object is flat (say a 2ft x 2ft piece of acrylic) you will need to remove the rubber feet to get the laser low enough to cut/engrave. Those are held in with M5 cap screws (4mm hex key). Again, do not remove the 4 cap screws that hold the plates onto the framing.
amboggeri
 
Posts: 30
Joined: Thu Dec 22, 2011 11:02 am


Return to CO2 Laser Products

Who is online

Users browsing this forum: No registered users and 5 guests

cron