*******************************ProgramStart**********************************

(Program posted with Full Spectrum Engineering Laser Post)
(Start Project in Mill Mode)
(Set PWM power in Rapid Height, 100=10%, 1000=100%)
(Set FeedRate in CutDepth)
G17 (active plane)
G40 (turn compensation off)
G20 (inch mode) 
G90 (Absolute mode, current coordinates)
G92 X0.Y0. (Set global offset current position as 0,0)

********************************ToolChange***********************************



********************************ChainStart***********************************


***********************************Rapid*************************************

G{MODE} X{XPOS} Y{YPOS}
S{RAPIDHEIGHT} (Spindle Speed Sets Power)
{SPINDLEON}

***********************************ZRapid************************************

S{RAPIDHEIGHT}
{SPINDLEON}

************************************Line**************************************

[G{MODE}][ X{XPOS}][ Y{YPOS}][ F{ZPOS}]


************************************Arc***************************************

[G{MODE}][ X{XPOS}][ Y{YPOS}] I{IPOS} J{JPOS}[ F{FEED}]


********************************CanCycleStart*********************************

M3 (Laser On)

**********************************InCanCycle**********************************


**********************************CanCycleEnd*********************************
M5 (Laser Onff)

************************************ChainEnd**********************************

M5 (Laser Off)

**********************************ProgramEnd**********************************

M5 (Program End)
M30 (End)